Vax ALL TERRAIN V-125 User Manual

www.vax.co.uk
8
operation
Fill tank (A) with warm tap water (Fig.4/10).
CAUTION: Do not fill with water above 50°C.
Fill solution container (B) with Vax Ultra Carpet/
Upholstery Solution (Fig.4/11).
NOTE: DO NOT remove solution container from tank.
IMPORTANT: Do not use any type of wax with
your cleaner.
IMPORTANT: To assure proper results, use only
Vax carpet cleaning solutions.
IMPORTANT: Do not use hard floor cleaning
solution on carpets or upholstery.
Replace container cap and tighten.
Position bottom of tank onto cleaner using one hand on
each side of the tank to center it on the unit. Pivot the
tank towards the back of the unit (Fig.4/12).
Push the top of the tank and tank handle while supporting
the back of the unit with your other hand (Fig.4/13).
Push up on the handle once the tank is back to latch it to
the unit (Fig.4/14).
Check tank to make sure it is securely latched.
NOTE: There may be a small amount of water
(indicated by arrows - Fig.4/15) on the base when the
tank is removed from the unit. This is a normal
condition.
Recovery Tank (Lower Tank)
The recovery tank holds the dirty solution that is picked up
fr
om the surface being cleaned.
When the r
ecovery tank is full, the automatic shut-off will
engage, suction will stop (see page 6), and the tank must
be emp
tied.
!
!
!
Fig.4/12
Fig.4/15
Fig.4/13
Fig.4/14
Fig.4/10
Fig.4/11
A
B

Vax ALL TERRAIN V-125 Specifications

General

Brand	Vax
Model	ALL TERRAIN V-125
Category	Vacuum Cleaner
Language	English