Getting Started
vax.com.au 6
To remove lid, rotate
anti-clockwise.
Place the floor head on top of the velcro microfibre pad
making sure the mop head covers the entire pad.
The blue face should be in contact with the floor and velcro
side attaches to the floor head.
Using the measuring jug and
funnel, only fill up to 1.4L. Allow
space to be left at the top.
Ensure the lid is securely
fastened by rotating clockwise
before use.
Filling clean water tank
Attaching the velcro microfibre cleaning pad
Before you begin cleaning
IMPORTANT: Your detergent control dial will be set to ‘tough stains’ when you remove your steamer from
the box. If you do not want to use detergent on your hard flooring/hard surfaces, this must be rotated to the
‘steam/refreshes carpets only’ position. Always test on an inconspicuous area of flooring/surface first
before using detergent.
IMPORTANT: Do not use hot or boiling water to fill clean water tank. Do not over fill the water tank.
IMPORTANT: Do not operate your steam cleaner without water in the clean water tank.
For use on sealed hard floors or refreshing carpets.
WARNING: To reduce the risk of personal injury, unplug the steamer when fitting the cleaning pads.
IMPORTANT: Never use the steam cleaner without a cleaning pad attached to the floor head.
To Next Page
Loading...
Need help?
General
