Using your machine
Before you begin cleaning
• Always switch o and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat, the
thermostat will automatically turn the vacuum cleaner o. If this happens, switch the vacuum cleaner o and unplug from
the electrical socket. Remove and empty the dirt container and also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the lters to fully
dry before putting back into the vacuum).
• Pre-motor lters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch o and unplug before removing the blockage.
• When using the accessories always make sure the machine is stood in the upright position.
Extension tube
Remove the hose end
from the oorhead.
Remove the
extension tube.
Choose an accessory.
2-in-1 tool converts into:
A = Crevice Tool
B = Dusting Brush
Attach the accessory
to the hose end.
3-in-1 Tool converts into:
A = Crevice Tool
B = Upholstery Tool
C = Dusting Brush
A
B
C
Attach the accessory to the
extension tube.
Attaching the hose
Attach the hose to the
extension tube.
Using accessories
NOTE: The Turbotool, 2-in-1 Tool and 3-in-1 Tool can all be attached to the tube or directly to the hose.
NOTE: The brushbar will not spin until the machine is reclined.
To Next Page
Loading...
Need help?
General
