Vax MachAir UCA2GEV1 - Maintaining Your Vax MachAir; Using the Air Vent for Suction Control; Emptying and Cleaning the Dirt Container; Cleaning the HEPA Pre-Motor Filter

Taking care of your machine
Emptying and cleaning the dirt container
How to use the air vent
Cleaning the HEPA pre-motor lter
Press the dirt container release button and pull
to remove the dirt container.
Slide the vent cover open to decrease suction,
if required on high piled carpets.
Turn the dirt container lid
anti-clockwise…
Tap the lter over a bin
to release any dirt.
Hold the dirt container over a bin and press the dirt
container release button allowing dirt to fall out.
Close the vent cover to increase suction,
for maximum cleaning on hard oors.
…and lift to remove.
Wash the lter under
running water (40°C max).
Grasp the tab on the lter
and pull to remove.
Leave to fully dry for at least
24 hours before putting back
into the vacuum cleaner.
40°C max
tap
!
!
!
!
24hr
MAX
40˚C
!
MAX
40˚C
NOTE: For most ecient results the air vent should be closed.