8
Maintenance (Keep your Vax as good as new)
Removing blockages from the TurboTool
Removing blockages from the Turbobrush
Locking ring
Turn the TurboTool over and slide o
the locking ring.
Switch the vacuum cleaner o and
disconnect the power plug from the
electrical outlet.
Lay the Turbobrush on a at surface
and turn over to expose the brushbar.
Using a pair of scissors, cut through
any threads or hairs caught around
the brushes and brushbar.
Clearing blockages
WARNING: To reduce the risk of electric shock, the power cord must be disconnected before performing
maintenance/troubleshooting checks. Turn the vacuum cleaner o and unplug from the electrical socket.
Hose blockages
The exible hose may be disconnected from the
vacuum cleaner. Carefully remove any blockages found
and reconnect the hose securely.
Accessory blockages
Remove accessory from the hose/telescopic tube.
Carefully remove the blockage and return to the cleaner.
Detach lower housing and
remove blockage.
To re-assemble the TurboTool,
ensure that the tabs are engaged
and pivot the lower housing closed.
Slip the locking ring over the neck
of the TurboTool and into the groove
to nish.
To Next Page
Loading...
