Using your machine
Refreshing carpets
Place your foot onto the
oor head and pull handle
backwards to recline
When using on carpets, always
make sure the microbre cleaning
pad is used and covers the oor
head entirely before using the carpet
glider. Only use the carpet glider
when refreshing carpets.
WARNING
Refreshing carpets
To produce steam,
squeeze the trigger.
To prevent over wetting
oors avoid holding the
trigger continuously
Move the steam mop slowly
backwards and forwards across
the carpet paying particular
attention to high trac areas
To release the carpet glider,
place your foot on clip and
push down. Lift steam mop
to remove
WARNING: Always turn OFF the steam mop when tting the cleaning pads.
IMPORTANT: Never use the steam mop without a cleaning pad attached
to the oor head. Never leave the steam mop in one spot for extended period
of time or with a damp or wet pad attached as this may
damage the oors surface.
To Next Page
Loading...
Need help?
General
