Taking care of your machine
Checking hose: While vacuum cleaner is o and unplugged. Remove wand and all attachments from hose.
Plug in vacuum and turn on. Check suction level at the end of the hose. If low suction is detected, turn o vacuum
and unplug. Clear blockage in hose.
Checking for and clearing blockages
Check nozzle: While vacuum
is o and unplugged, detach
nozzle from wand. Turn vacuum
over so bottom side is facing
up. Remove 6 screws from
bottom plate as shown.
Pivot bottom plate out to
access brushroll.
Check wand: Turn vacuum o
and unplug. Remove wand
from hose AND remove nozzle
from wand. Visually inspect
wand looking through from
one end to the other.
If daylight cannot be seen,
clear blockage.
Clean debris from brushroll.
Also check and clear any
blockages in nozzle around
wand connection.
Reposition bottom plate and
refasten all (6) screws.
To Next Page
Loading...
