Taking care of your machine
Taking care of your machine
IMPORTANT
An Auto Reset Thermal Protector has been designed into your cleaner to protect it from overheating. When the Auto
Reset Thermal Protector activates the cleaner suction motor will stop running.
If the vacuum stops running proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet. *IMPORTANT: If left plugged in and turned on, the cleaner
suction motor may restart unexpectedly.
2. Empty dirt cup.
3. Inspect the nozzle inlet, nozzle connector, hose connector, hose, wand, primary lter and HEPA lter. Clear
obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the Auto Reset Thermal Protector will deactivate and
cleaning may continue.
If the Auto Reset Thermal Protector continues to activate after following the above steps, your cleaner needs servicing.
Cleaning the pre-motor fi lter
Familiarise yourself with these home maintenance tasks as proper use and care of your cleaner will ensure
continued cleaning e ectiveness.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a service center prior to continuing use.
Dirt cup
WARNING: To reduce the
risk of personal injury -
Unplug vacuum before
cleaning or servicing.
Do not use vacuum without
dirt cup or lters in place.
Very ne materials, such as
face powder or cornstarch,
may seal the lter and
cause a reduction in
performance. When using
the vacuum for this type
of dust, empty the cup and
clean the lters often.
When to Empty
Empty the dirt cup and before
the dirt reaches the max ll
line or at the end of each
cleaning session.
How to Empty
Press button on the handle
located on the dirt cup lid and
pull dirt cup out.
Holding dirt cup over trash
receptacle, press dirt cup
door release button to open
and empty dirt cup. When all
the dirt has fallen, close the
dirt cup door and replace.
To Next Page
Loading...
