Taking care of your machine
Taking care of your machine
CAUTION: Do not use sharp objects to clean out hose as they can cause damage.
WARNING: To reduce the risk of personal injury - Unplug vacuum before cleaning or removing hose, wands,
tools and accessories to check for or clearing blockages.
Checking for and clearing blockages
Low suction or pick up may be due to a blockage in the system. Refer to the following steps to check for blockages,
continuing with each step until the blockage is found.
The motor and brushroll are equipped with bearings which contain suffi cient lubrication for their lifetime.
The addition of lubricant could cause damage. Do not add lubricant to motor or brushroll.
Lubrication
Checking vacuum connection: While vacuum cleaner is o and
unplugged, remove hose from vacuum cleaner, visually check
hose inlet on canister for blockages and remove if any is found.
Reconnect hose.
To Next Page
Loading...
Need help?
General
