SETUP the Cleaner from DRY to WET Vacuuming
NOTE: Empty the tank and dispose of any dirt/dust which may have been picked up previously in dry mode.
NOTE: Clean and dry the inside and outside of the machine before storage.
IMPORTANT: Never vacuum dry dust and dirt with just this foam lter tted as it will provide little or no protection,
resulting in motor damage. To be used in wet mode only.
When vacuuming up uids
– the crevice nozzle can be
used when the water level
is too high to use the oor
tool. To ensure the
air ow is adequate, we
recommend that the end
of the nozzle is not totally
immersed.
Once the water tank is
emptied, place the top
motor housing cover back
onto the main tank and
secure into position with
the two retaining clips.
Connect the vacuum
cleaner to the power supply
and switch ON
by pushing the on/o
switch “I” to continue
to vacuum in wet mode.
When the uids have
reached the maximum tank
capacity, the oat regulator
will cover the motor lter
causing the motor to work
harder and it will become
noticeably nosier. At this
point turn o the machine
and unplug it from the mains
power and empty the tank.
Remove the dry lter and
replace it with the foam
lter – this slides over the
oat cage as shown.
Place the top motor housing
cover onto the main tank
and secure into position
with the two retaining clips.
Remove dust bag from
tank.
Using your machine
To Next Page
Loading...
