Getting Started
Insert the backbone into
the oorhead.
Insert the cord holder into
the hole at the bottom of the
product backbone.
PLEASE READ SAFETY INFORMATION BEFORE USE (p3)
Assembling your upright
Before plugging the cord into the electrical outlet, make sure the switch is in the ‘o’ position. Hold the vacuum cleaner
rmly when starting and in use.
Now take the small clip and
push it down between the
end of the cord holder and
the machine, to lock the cord
holder in place.
1. Insert the short end of
the hose into the tube at
the back of the machine.
2. Wrap the hose around
the machine and
connect the hose end
to the oorhead.
1. Place the dirt container
onto the product and
click in place to secure.
2. Store the extension tube
in to the handle then
Insert the handle at the
top of the product.
Hose connector ts into the
air inlet tube bayonet.
1. Attach TurboTool clip to
the handle
2. Snap TurboTool into
position.
Attach hose clip to the
air inlet tube.
Plug in and switch on
your machine.
4vax.co.uk
To Next Page
Loading...
