SER
• Flashing yellow indicates that there is incoming Serial traffic through this socket.
• Flashing green indicates that expected incoming CAN data has been decoded properly and is being logged.
BLUETOOTH
• V1 Bluetooth module - Flashing blue indicates Bluetooth is waiting for a connection.
V2 Bluetooth module – Flashing blue indicates Bluetooth is initialising coms with a Bluetooth device.
• Solid blue indicates the VBOX3i has a Bluetooth connection with another Bluetooth device.
CF
• Flashes blue when data is being written to the card.
LOG
• Solid green when the VBOX is capturing data to the CF card.
• Flashes red indicating current logging rate after ‘FUNC’ button press, fast for 100 Hz, slow for 20 Hz.
IMU (V2/V3/V4/V5 only)
• Solid orange indicates that IMU integration is enabled but no IMU is connected, or, the detected IMU is invalid.
When using an IMU04, ensure that it is: connected using an RLCAB119 to the 25-way D connector, is set to
Racelogic CAN mode, and is running the latest release firmware.
• Flashing orange shows IMU is connected and integration initialisation is running. This will not complete until the
VB3i has had a satellite lock whilst stationary for 30 seconds.
• Flashing green indicates Initialisation complete – movement not yet detected.
• Solid green indicates movement detected – IMU integration working OK.
VB3i V1
When IMU Integration is enabled and the IMU is connected, the satellite LED will remain off to act as an indicator for
the IMU integration status. Only when the filter is initialised and movement is detected will the SAT LED return to its
normal operation.
The user will need to leave 1 minute after powering the VBOX on with the IMU connected before starting to move. This
occurs on every power up of the VBOX unit.
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_3i_Range/VBOX_3i_User_Guide_(All_Variants)/04_-
_VB3i_LED_Indicators
21
To Next Page
Loading...