Note for VB3i V1 units
When the filter is enabled and the IMU is connected, the satellite LED will remain off to act as an indicator for the IMU
integration status. Only when the filter is initialised and movement is detected will the SAT LED return to its normal
operation.
The user will need to leave 1 minute after powering the VBOX on with the IMU connected before starting to move. This
occurs on every power up of the VBOX unit.
DIFF/DGPS
• Off indicates that no DGPS mode is set or is in MB-Base mode.
• Flashing orange indicates DGPS is set but not locked (either 2 cm RTK, 40 cm local DGPS, MB-Rover or NTRIP).
• Solid orange indicates a 'Float' RTK status (either 2 cm RTK, MB-Rover or NTRIP) or ‘Fixed’ DGPS lock (40 cm
local DGPS or SBAS).
• Solid green indicates a ‘Fixed’ RTK lock (either 2 cm RTK, MB-Rover or NTRIP).
DUAL (VB3i D/DR units only)
• Solid orange indicates that dual antenna mode is enabled.
• Solid green indicates dual antenna lock is fixed.
PWR
• Solid green indicates that a suitable power source is connected, unit is fully booted and ready to use.
• Solid red indicates that the VBOX is not ready to operate either because it is still booting up, settings are being
written to the unit or because there is an error condition.
D IN
• Solid green indicates that the brake trigger input has been activated/triggered.
CAN
• Flashing green indicates that expected incoming CAN data has been decoded properly and is being logged.
• There is no illumination to indicate that there is incoming Serial traffic through this socket.
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_3i_Range/VBOX_3i_User_Guide_(All_Variants)/04_-
_VB3i_LED_Indicators
20
To Next Page
Loading...