assigned to the substitution speed channel. VBOX will recognise the following unit names: MPH, KM/H, Knots, m/s, and
ms-1.
Note: If no UNITS have been assigned to the input channel then VBOX will assume that it is KM/H.
This function is useful while testing around built up areas or driving under large bridges.
VB3i CAN Termination
The VBOX3i contains an active termination between 0 Ohms and 120 Ohms, the active terminations are selectable
via VBOX Setup as shown below.
Note: When the Usage of the CAN ports is swapped from one output socket to the other the termination resistor setting
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_3i_Range/VBOX_3i_User_Guide_(All_Variants)/08_-
_VB3i_CAN
38
To Next Page
Loading...