To Next Page
T
taylorrobinsonAug 29, 2025
What to do if the directions cannot be heard or are very quiet on my VDO MS 4150 RS?
- KkmcbrideAug 29, 2025
Press the Info button and set the required Nav volume.
What to do if the directions cannot be heard or are very quiet on my VDO MS 4150 RS?
Press the Info button and set the required Nav volume.
What does it mean if my VDO MS 4150 RS display shows 'Tune to next TA station' and a warning tone sounds?
If “TA Scan” is switched on, the selected station may be too weak or not transmit traffic announcements (TA). Deactivate the “TA Scan” function or set another station.
Why is the estimated time of arrival incorrect on my VDO MS 4150 RS Car Receiver guidance screen?
Check the time zone in the “INITIALISATION - CLOCK SETTINGS” menu, especially if the GPS clock is set.
Why does my VDO MS 4150 RS system switch off the sound during driving or display 'PHONE IN/MUTE'?
This issue occurs when the speedometer signal is connected to the wrong pin of the power supply connector. Refer to the installation instructions for the correct pin setting in ISO chamber A.
What to do if my VDO MS 4150 RS Car Receiver displays 'Temperature too high' and lowers the volume?
The unit has an integrated safety circuit that prevents the temperature inside from exceeding a certain value. Allow the VDO Car Receiver to cool down by setting a lower volume and wait until the 'Temperature too high' message disappears from the display.
What does it mean when my VDO MS 4150 RS displays 'Please insert map CD'?
The map CD is required for some functions in navigation mode and for route planning. Insert the C-IQ map CD into the radio CD drive with the label facing upwards.
What does it mean when my VDO MS 4150 RS Car Receiver displays 'Please insert correct CD'?
Check that you have inserted a map CD which contains C-IQ data. Map CDs without C-IQ will not be accepted by the system.
General| Brand | VDO |
|---|---|
| Model | MS 4150 RS |
| Category | Car Receiver |
| Language | English |
