6
compartment as batteries.
3.5 Mounting position of the inverter
The inverter may be mounted horizontally on the top of a horizontal surface or under a horizontal
surface. The inverter may be mounted on a vertica1 surface only horizontally
3.6 Getting Connected
Follow the connection sequence described below.
Step1 Ensure that the ON/OFF switch on the Inverter is in the OFF position. If the power source
is a DC power supply, switch it OFF as well.
Step2 Connect inverter to power source.
Connect the DC cables to the DC battery terminals on the rear pane1 of the inverter. The red
termina1 is positive(十) and the black terminal is negative(-).
Step3 Connect inverter to appliances.
Make sure the1oad power within the rated power of inverter and the start power should not exceed
the peak power of the inverter. When having the inverter connected with appliances and a power
supply, switch on the inverter and appliances. If you are operating several loads from the power
inverter, tum them on separately after the inverter has been turned on. This will ensure that the
power inverter does not have to deliver the starting currents for all the loads at once.
4. IMPORTANT SAFETY INSTRUCTIONS
Incorrect installation and misuse of the inverter may result in danger to the user or hazardous
conditions.
1. Do not attempt to connect the any other power source, including any AC power source.
2. Make sure the opening to the ventilation fan and vent holes are not blocked.
3. Avoid pulling on the cords and cables. Always grip plugs firmly when unplugging from power
source and when disconnecting cables.
4. To avoid electrical hazard, be sure to unplug the inverter from its external power source before
inserting the AC plug.
5. For indoor use only. Avoid exposure to external heat sources; direct, pro1onged sunlight; dust;
corrosive chemicals; and moisture.
6. It is norma1 for inverters to become warm during use. Avoid touching the device during use.
Avoid placing in direct sunlight or near heat-sensitive materials.
7. Do not drop or subject the inverter to undue shock.
8. Do not place anything on top of the inverter.
9. Always with the supplied cables and connectors as shown. Use of cables, connectors, or
accessories not supplied with this product constitutes misuse and may result in injury or damage.
10.Do not attempt to service or dissemble. The unit is not user-serviceable. Attempting to
To Next Page
Loading...