To Next PageTo Next Page
Need help?Do you have a question about the Veeco VT-102 and is the answer not in the manual?
General| Category | Microscope |
|---|---|
| Type | Atomic Force Microscope (AFM) |
| Manufacturer | Veeco |
| Model | VT-102 |
| Noise Floor (Z) | < 0.05 nm |
| Operating Modes | Contact Mode, Tapping Mode |
| Sample Size | Up to 200 mm diameter |
| Controller | Nanoscope IIIa |
Details the safety requirements for installation and operation.
Covers essential precautions to avoid injury and damage to samples or equipment.
Provides critical steps for powering up the system during installation.
Identifies and explains hazard labels found on the SPM.
Detailed instructions for physically installing the SPM unit.
Procedures for connecting all system components and cables.
Steps for powering up the system after installation.
Covers fundamental AFM operations like selecting modes and preparing components.
Outlines the fundamental steps for operating in Contact Mode AFM.
Covers the essential steps for performing TappingMode AFM.
Covers essential safety precautions for fluid handling.
Covers the fundamental steps for operating the STM.
Covers the fundamental steps for performing MFM.
Describes automated methods for X-Y axis calibration.
Detailed instructions for calibrating the Z-axis measurements.
Covers common problems and error messages.
