Veeder-Root SERIES 7887 - Page 14

Installation, Operation and Service Manual
Series 7886 High-Capacity & 7887 Meter Registers
6. Right-Hand Side Plate Installation
a. Hold meter register assembly as shown in Figure 22 and
place a rubber band around the assembly to hold it
together. Be sure the pin in the reset lever group
remains engaged in the slot in the reset arm.
b. Install side plate over wheel shaft first, then engage the
other shafts.
c. Temporarily secure the side plate to the rear mounting
bar with screws.
7. Bracket Group (if required) and Totalizer Installation.
a. If required, install new bracket group to inside of left
side frame and secure with two screws and lock-
washers. See Figure 31.
b. Install pointer with screw (saved from old totalizer)
onto new totalizer group but do not tighten screw
securely. Pointer position must be adjusted after
totalizer group is installed. See Paragraph F, 2.
c. Install the totalizer group so that the bevel gear is in
mesh with the top bevel gear on the bracket group and
secure with retaining screws. For adjustment of bevel
gear drive, see Paragraph E, 5.
8. Spring Installation.
a. See Figure 23 for identification of springs. \,
b. Install the five anti-topping finger springs between the
anti-topping fingers and the stop shaft. See Figure 24.
c. Install the reset spring between the reset lever and the
pinion shaft.
d. Install the detent spring between the detent lever
group and the stop shaft.
e. Install the clutch spring between the clutch lever group
and the pinion shaft.
9. Pinion Shaft Assembly Installation
a. If not previously accomplished, remove all parts from
pinion shaft.
b. Rotate wheel shaft so reset fingers are fully engaged in
the heart-shaped cams on each wheel.
c. Place pinions, with short finger up, in between each
wheel as shown in Figure 25.
d. Install the end of the shaft closest to the two retaining
ring slots into the left-hand side plate and through each
pinion.
Figure 20. Reset Finger Shaft Group Preparation For
Installation.
Figure 22. Preparation For Side Plate Installation.
y _
Figure 21. Reset Lever Group Pin Engagement.
12
Figure 23. Spring Identification.