Veeder-Root SERIES 7887 - Final Checks and Adjustments

Installation, Operation and Service Manual
Series 7886 High-Capacity & 7887 Meter Registers
e. Install washers and detent lever group onto shaft and
engage shutter with tab on detent lever.
f. Push shaft through the right-hand side plate and
secure with washer and retaining ring.
g. Secure detent lever group into position with retaining
rings.
h. After assembly, rotate wheel shaft to make sure all
pinions have been positioned properly. If binding
occurs, reposition pinions per step c.
10. Reset Gear Installation.
a. Install reset gear on wheel shaft, aligning orientation
mark made at disassembly.
b. Secure gear to shaft with pin.
11. Reset Idler Gear Installation.
a. If present, install reset idler gear on the reset idler gear
shaft. See Figure 8.
b. Secure with retaining ring.
Note: This gear will be timed when the meter duplicator and
meter register are assembled together.
Figure 24. Anti-Topping Finger Spring Installation.
Figure 26. Installation Of Meter Register Onto
Mounting Fixture.
Figure 25. Pinion Positioning. Figure 27. Securing Mounting Fixture.
13