Veeder-Root SERIES 7887 - Operational Check After Service

Installation, Operation and Service Manual
Series 7886 High-Capacity & 7887 Meter Registers
Adjust to give proper engagement
with Drive Gear on Gear Plate
End Play
O.OO5-O.O12 inch
Maintain proper engagement
with Totalizer bevel gear.
CLUTCH SHAFT
Washer Clutch and Anti-topping Shafts
end play for proper actuation of Clutch
End Play
0.007 inch maximum
Adjust Detent Lever for best possible
engagement while maintaining
0.005-0.010 inch end play
to
End Play
0.005-0.012 inch
PINION SHAFT
End play of
0.002-0.007 inch
between retaining rings
Adjust No-back Pawl for best possible
engagement while maintaining
0.005-0.010 inch end play
End Play
0.005-0.012 inch
0.005-0.010 inch end play
between retaining rings.
ANTI-TOPPING FINGER SHAFT
RESET FINGER SHAFT
0.009-0.016 inch end play between
retaining rings of each wheel.
i
[I
t
Adjust for best possible engagement
of Reset Cam while maintaining
0.005-0.010 inch end play.
End Play
0.005-0.012 inch
WHEEL SHAFT
S
Figure 28. End Play Limits.
14