Operation Viewing PMC Reports Via RS-232 Connection
Table 3. Serial Commands for PMC Diagnostic Reports
Report Type Serial Command (PC to Console)*
Vapor Processor Status Report
(See example Figure 13)
<SOH>IV8200
Vapor Processor Runtime Diagnostic Report
(See example Figure 14)
<SOH>IV8000
Percent Hydrocarbon Diagnostic Report (See
example Figure 15)
<SOH>IV8100
*<SOH> = Control A. For more information on TLS console serial commands, refer to
the V-R Serial Interface Manual.
Pressure Management Control
To Next Page
Loading...
