ISD Reports Viewing ISD Reports via RS-232 Connection
44
Balance Systems - Hose No Test Result
• If the Flow performance did not run, then an N is posted.
• If there were no events received to make any conclusion about the A/L value for the hose, the A/L value is
replaced with an N.
• If there are some events received, enough to calculate an average, but not enough to complete a test, the No
Test result will appear with an A/L average.
Balance Systems - Hose Pass Result
• When none of the above results, W, F, G, N appear, then it was a pass.
Balance Systems - Code Precedent (Listed high to low)
1. G,F - Flow Collect Failure (A/L) and Statistical Failure (BLKD).
2. W - Flow Collect Warning (A/L and Statistical Warning (BLKD).
3. PASS -Pass Flow Performance Test.
4. N - No Test - Flow Performance Test not completed.
Balance systems - Self Test Codes
• ISD-W - A self-test warning condition exists. See ISD Setup.
• ISD-F - A self-test warning condition persisted for 7 days and resulted in a Failure.
To Next Page
Loading...
