3 / 4
Veeder - Root Company
125 Powder Forest Drive
PO B ox 2003
Simsbury, C T 06070
Within the US and C anada: 1.888.561.7942
Outside the US and C anada: +1.860.651.2700
For Technical S upport: 1.800.323.1799
http://www.veeder.com/us/
ENMaintenance and repair instructions
WARNING
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND SAFETY PRECAUTIONS COULD CAUSE DAMAGE TO
PROPERTY, ENVIRONMENT, RESULTING IN SERIOUS INJURY OR DEATH.
It is essential that the warnings and instructions in this publication are carefully read and followed to protect both
the installer and others from serious or fatal injury.
WARNING
Heed the adjacent intructions to avoid equipment
damage or personal injury.
READ ALL RELATED MANUALS
Knowledge of all related procedures before you begin work is
important. Read and understand all manuals thoroughly. If you do not
understand a procedure, ask someone who does.
Safety Symbols
Contractor Certification Requirements
Notice
Veeder-Root makes no warranty of any kind with regard to this publication, including, but not limited to, the implied warranties of merchant-
ability and fitness for a particular purpose.
Veeder-Root shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing,
performance, or use of this publication.
Veeder-Root reserves the right to change system options or features, or the information contained in this publication.
This publication contains proprietary information which is protected by copyright. All rights reserved. No part of this publication may be
photocopied, reproduced, or translated to another language without the prior written consent of Veeder-Root.
Contact TLS Systems Technical Support for additional troubleshooting information at 800-323-1799.
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the equipment discussed in
this manual:
Installer Certification (Level 1): Contractors holding valid Installer Certification are approved to perform wiring and conduit routing;
equipment mounting; probe, sensor and carbon canister vapor polisher installation; wireless equipment installation; tank and line prepara-
tion; and line leak detector installation.
Technician Certification (Level 2/3): Contractors holding valid Technician Certifications are approved to perform installation checkout,
startup, programming and operations training, system tests, troubleshooting and servicing for all Veeder-Root Series Tank Monitoring
Systems, including Line Leak Detection. In addition, Contractors with the following sub-certification designations are approved to perform
installation checkout, startup, programming, system tests, troubleshooting, service techniques and operations training on the designated
system.
• Wireless 2
• Tall Tank
To Next Page
Loading...
Need help?
General
