Veepeak OBDCheck VP39 - Viewing Freeze Frame Data

- 12 -
• If the codes are not cleared, then an “Erase Failure. Turn Key on with Engine off!”
message displays.
4) Wait a few seconds or press any key to return to Diagnostic Menu.
• If you do wish to proceed to erase the codes, then press SCROLL button to select NO
and press ENTER/EXIT. A “Command Canceled” message shows up. Press any key or
wait a few seconds to return to Diagnostic Menu.
5) Some codes cannot be erased unless the issue with the vehicle is xed.
4.3 Viewing Freeze Frame Data
1) To view freeze frame, use SCROLL button to select View Freeze Frame from
Diagnostic Menu and press ENTER/EXIT button.
= = = = = = = = = = =3/6
Diagnostic Menu
1) Read Codes
2) Erase Codes
3) View Freeze Frame
4) I/M Readiness
►
• If more than one module is detected, you will be prompted to select a module before
test.
= = = = = = = = = = =1/3
Control Module
Engine
Module $A4
Exit
►
• Use SCROLL button to select a module and press ENTER/EXIT button.
2) Wait a few seconds while the code reader validates the PID MAP.
= = = = = = = = = = = = =
View Freeze Frame
Reading PID.01
- Please Wait -
3) If the retrieved information covers more than one screen, use SCROLL button, as
necessary, until all data have been shown up.