Veepeak OBDCheck VP39 - Vehicle Information Retrieval

- 15 -
5) If the vehicle supports readiness test of “This Drive Cycle”, a screen of the following
will be displayed:
= = = = = = = = = = = =1/3
This Drive Cycle
MIL Status ON
Misre Monitor OK
Fuel System Mon. OK
Comp. Component OK
• The number “x/x” to the upper right corner of the screen indicates total number of
screens the retrieved data cover and sequence of currently displayed data.
6) Press ENTER/EXIT button to return to previous menu.
4.5 Viewing Vehicle Information
The Vehicle Info. function enables retrieval of the Vehicle Identication No. (VIN),
Calibration ID Nos. (CINs), Calibration Verication Nos. (CVNs) and In-use Performance
Tracking on 2000 and newer vehicles that support Mode 9.
1) Use SCROLL button to select Vehicle Info. from Diagnostic Menu and press
ENTER/EXIT button.
= = = = = = = = = = = =5/6
Diagnostic Menu
5) Vehicle Info.
6) Exit
►
2) Wait a few seconds or press ENTER/EXIT button to continue.
= = = = = = = = = = = = =
Vehicle Info.
Turn key on
with engine off!
Press [ENTER] to con.
• If the vehicle does not support this mode, a “The selected mode is not supported!”
message shows on the display.
• If more than one module is detected, you will be prompted to select a module before
test.