Vega VEGACONNECT - 3.3 Adjustment; 3.4 Packaging, transport and storage

8
3 Product description
VEGACONNECT • Wired interface adapter with connection box
66081-EN-211221
The VEGACONNECT can be connected to all communication-capa-
ble VEGA instruments with respective interface. All currently available
electronics versions are supported.
Connection cable, adapter and terminals for connection to the dif-
ferent instrument series are attached to all VEGACONNECT. These
adapters can be kept in the storage space of the connection box.
The Bluetooth USB adapter enables the wireless adjustment of VEGA
sensors with a Windows PC. For this, a PLICSCOM with Bluetooth
option integrated in the sensor or an instrument with integrated
Bluetooth function are required. In this case, the VEGACONNECT is
not used, here the connection box is only a preserving possibility for
theBluetoothUSBadapter.Youcanndfurtherinformationofthisap-
plication in the operating instruction of PLICSCOM or the instrument
with integrated Bluetooth function.
The magnet pen enables the adjustment of the buttons of a Blue-
tooth-PLICSCOM with closed housing lid with inspection window.
In this case, the VEGACONNECT is not used, here the connection
boxisonlyapreservingpossibilityforthemagnetpen.Youcannd
further information of this application in the operating instruction of
PLICSCOM.
The interface adapter is connected via the USB interface to a PC. It
converts signals and protocols of the USB interface into the appropri-
ate signal/protocol of the connected instrument.
The voltage supply is provided via the USB interface of the PC.
3.3 Adjustment
The adjustment is carried out via a Windows PC with a parameter
adjustment software such as PACTware with respective DTM. There
are no adjustment elements on the instrument itself.
3.4 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging consists of environment-friendly, recyclable card-
board. For special versions, PE foam or PE foil is also used. Dispose
of the packaging material via specialised recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Bluetooth USB adapter
Magnetic pen
Functional principle
Voltage supply
Packaging
Transport
Transport inspection