Vega VEGAMET 862 - Wiring Plan

17
5 Connecting to power supply
VEGAMET 862 • 4 … 20 mA/HART
58867-EN-200401
Information:
Solidcoresaswellasexiblecoreswithwireendsleevesare
inserteddirectlyintotheterminalopenings.Incaseofexiblecores
without end sleeves, a small screwdriver must be pressed into the
rectangular opening so that the terminal opening is then free. When
the screwdriver is pulled out, the terminals are closed again.
Youcanndfurtherinformationonthemax.wirecross-sectioninthe
technical data.
Connect the device as described in the following wiring plan.
5.5 Wiring plan
12 3
12 3
4
212223
91 92
LN
+- +-+-+-
61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 41 42 43 44 45 46 123
456
24 2526 27282930 3132
Power
65432
1S
ensor 1
Relay Output Current Output
Digital IN
Sensor 2
5
1 2 3
6 7
4
8
Fig. 6: Wiring plan VEGAMET 862
1 Voltage supply of the controller
2 Relay outputs 1 … 6
3 Current outputs 1 … 3
4 Sensor inputs 1/2 (active/passive)
5 Digital inputs 1 … 4
6 Ground terminal for protective conductor
7 Ground terminal for cable screening
8 Ground terminal for potential equalization
Connecting