To Next PageTo Next Page
Need help?Do you have a question about the Veichi AC10 Series and is the answer not in the manual?
Provides safety precautions and explains warning signs to prevent injury or damage.
Emphasizes paying attention to all safety information in the book to prevent death or serious injury.
Highlights warnings for safe installation and operation to ensure user safety and product performance.
Specifies environmental requirements for installing the drive for optimal long-term use.
Provides guidelines on drive installation direction and required ventilation space for cooling.
Explains the regulations for safe and reliable wiring of the drive, including earth connection and cable separation.
Illustrates the standard NPN connection diagram for the drive's control circuit terminals.
Illustrates the standard PNP connection diagram for the drive's control circuit terminals.
Details the main circuit terminal arrangement and definitions for AC10 series drives.
Shows the control circuit terminal arrangement for 0.4kW-5.5kW and 7.5kW-22kW drives.
Provides connection diagrams and suggested braking resistance specifications for AC10 series drives.
Emphasizes safety information to prevent death or serious injury during operation.
Outlines the basic initial startup procedure for the drive, guiding users through basic settings.
Lists confirmations required before turning on power to ensure safety of personnel and the drive.
Explains self-tuning methods for motor characteristic measurement and parameter setting for vector control.
Details self-tuning modes, applicable conditions, and input data for asynchronous motors.
Provides instructions for performing trial runs after setting basic parameters and self-tuning the motor.
Describes how to adjust control faults like offset or vibration using parameters for V/f and PG-free vector control.
Emphasizes safety information to prevent death or serious injury related to network communication.
Explains MODBUS communication interface, protocol, and master-slave configuration for centralized control.
Emphasizes safety rules to prevent personal injury or death due to dangerous voltage and moving mechanisms.
Explains fault, warning, and prompt code types, and actions taken by the drive during these events.
Provides a list of fault, warning, and prompt codes with detailed reasons and countermeasures.
Provides safety precautions to prevent electric shock and fire during overhaul and maintenance.
Provides safety precautions regarding electric shock and fire during scrapping.
User safety rules for using peripheral equipment and selecting components, including power-off procedures.
Emphasizes safety information to prevent death or serious injury during operation.
Configures functions for digital input terminals X1-X4, including run commands, fault reset, and external input.
Defines drive start modes: start frequency, DC braking, and speed tracking start.
Sets overcurrent suppression, load current limit, and wave-by-wave current limit functions to protect against overcurrent faults.
Configures bus overvoltage and undervoltage protection and suppression functions to prevent voltage-related faults.
Sets motor overload protection parameters, including curve coefficient and low-speed characteristics.
Configures stall protection actions and thresholds for speed deviation and rapid detection.
Covers PID controller settings for given signal source, feedback signal, and PID output adjustments.
Covers PID controller settings for given signal source, feedback signal, and PID output adjustments.
Details PID control selection, preset output, deviation limits, proportional, integral, and differential gains.
General