Vello Freewave - Pairing Transmitter to Receiver

4
Note: The transmitter and
receiver sets come paired
together.
. Slide the receiver’s
battery compartment
cover towards the rear
for removal and turn the
receiver on.
PAIRING THE TRANSMITTER TO A RECEIVER
2. Press the recessed
transmitter code set
button. Use a pin-like
object that will fit into the
recessed hole.
3. After pressing the button,
the status indicator light
will blink repeatedly. This
signals that the receiver is
in pairing mode and is ready
to receive the transmitter’s
code. After 5 seconds, the
receiver will exit pairing
mode.