Vello Freewave - Page 22

22
code. After 5 seconds, the
receiver will exit pairing
mode.
5. Press the pairing/test button
on the first transmitter. The
receiver’s status indicator
light will blink twice, and
then continue to blink
repeatedly for up to 5
seconds.
6. In these 5 seconds, you
will need to press the
pairing/test button on
the next transmitter, and
so on for the remaining
transmitters. The receiver’s
status indicator light
will blink twice and then
flash repeatedly again
for 5 seconds after each
transmitter has been paired.