Velodyne EQ-Max Series User Manual

WWW.VELODYNE.COM
4 - EQ-Max Series User’s Manual
Auto Turn on Function
The subwoofer will turn itself on automatically when an audio signal is present. If no signal is present for
approximately eight minutes, the unit will switch to standby mode (blank leD). While in standby mode, your
subwoofer will draw very minimal power. your sub is shipped in the “Always on” position. In order to activate
the circuit, change the switch to “Stand-by”.
Warning:
If the Sub-out channel signal level from your receiver is too weak, this feature will not operate properly
and shut the subwoofer off while you are listening to it. To correct this, see the VOLUME CONTROL
section above.

Velodyne EQ-Max Series Specifications

General

Enclosure Type	Bass Reflex
Auto On/Off	Yes
Driver Size	12 inch
Inputs	Line-Level
Outputs	Line-Level
Phase	0 or 180 degrees