If you have a VELUX INTEGRA
®
control pad
KLR 200, you can copy the registered prod-
ucts from the control pad to the interface.
See pages 14-18.
Note: If you have both a control pad KLR 200 and a control keypad
KLI 110, you can copy the registered products from both controls
using control pad KLR 200.
io-homecontrol
®
products must be registered in the interface to be
operational. You can register and operate up to 200 products.
Function as interface
Registration of products
If you only have a VELUX INTEGRA
®
control keypad KLI 110, you can copy the
products operated by this control to the
interface. See pages 19-21.
Function as interface
Functions of inputs
A single contact can be used for run-
ning products either up or down – can
for example be used for a blind.
Short press (under 1 second): The
product will run to end position.
Long press: The product will run until
the key is released.
A set of two contacts can be used for
running products both up and down
with variable stops by pressing both
contacts simultaneously.
A change-over contact can also be
used for running products both up and
down but stops are not possible – can
for example be used for a thermostat.
To Next Page
Loading...
