9 VELUX
®
VELUX
®
10
ENGLISH ENGLISH
Operation
Keys for operating the product
A
OPEN/UP/ON or CLOSE/DOWN/OFF
Short press: Product will travel to end position.
Long press: Product will travel until the key is released.
Stop key
B
Short press: Product stops.
Fitting of holder for remote control
Note: Before the holder is fixed to the wall, it is recommended
to check if the remote control is able to operate the relevant
products from the fixed position.
If the power supply unit is to supply
more than one product with power,
you must buy control pad KLR 200 ad-
ditionally. The control pad will operate
the products individually.
On page 11 you can see how to copy
the contents of your remote control to
control pad KLR 200.
The remote control supplied is
designed for operating one product
connected to the power supply unit,
for instance one window operator,
one roller shutter, one roller blind or
one set of frame lights.
Fitting of remote control
If required, the remote control can be fixed to the holder as
shown.
Replacement of batteries
Insert new batteries (type AAA, 1.5 volt) as shown.
Resetting
The products connected can be reset by removing the lid of the
power supply unit and pressing the RESET button for at least
5 seconds. Registration is now possible, see the section Initial
set-up.
Note: The connected products will run briefly back and forth in
random order to indicate that they are ready for registration.
D E
F
G
H
To Next Page
Loading...
Need help?
General
