Vemer Dafne - Page 29

English
- 27 -
Dafne chronothermostat, user’s manual
3. The value of the flashing T1 temperature is
displayed. Modify the value with the keys
and and press the key to move
to the modification of T2.
4. The value of the flashing T2 temperature is
displayed. Modify the value with the keys
and and press the key to move
to the modification of T3.
5. The value of the flashing T3 temperature is
displayed. Modify the value with the keys
and and press the key to go
back to the page of T1 temperature.
6. Once all parameters are set, to exit and to
go back to the programming menu, press
for a short time the key
.
To exit and to go back to the normal
operation press for a long time the key
or wait for the time-out expiration (30
seconds about).
Attention: the set values of temperature
must respect the condition:
T1≤T2≤T3.
In cooling mode T1 is not
settable and equals off system.