Instructions for the installer, maintenance
technician and final user
19
2.6 Referral programming manual
All the machine’s control and operation settings can be set through the programming
routine of the SVE01 electronic board.
The programming routine of the electronic board is described in the SVE01
PROGRAMMING MANUAL supplied with the vending machine.
The referral programming manual will change depending on the version of the
software:
If the version of the software is 2.xx or more: the programming manual to which you
should refer it is p/n 410738.
The software version 2.xx or more it is able to manage the Master - Slave
connection.
If the version of the software is earlier than 2: the programming manual to which you
should refer it is p/n 412487.
The software earlier than version 2 does not manage the Master - Slave connection.
To Next Page
Loading...
Need help?
General
