Instructions for the installer, maintenance
technician and final user
38
5.6Start-up
To start-up the Vending machine, work as follows:
Assure that the plug is connected to the supply mains.
Give power to the Vendor: ppress the luminous green button MAIN SWITCH
situated on the transformer box inside of the machine (on the sliding panel next to
the cell).
On models with OutDoor kit to dive power to t he vending machine you must also
enable the magnetic circuit breaker on the bottom of the drawer.
The LED tubes switch on through the MAIN SWITCH placed on the front part of the
transformer box.
Execute the programming routine: refer to SVE01 Programming Manual
Load the vendor with the desired products
Close the vendor door and wait for the general machine check
The vendor is now ready for vending.
CAUTIONS: IN CASE OF FAILURE AND/OR BAD PERFORMANCE OF THE MACHINE,
CONTACT ONLY THE QUALIFIED PERSONNEL AT OUR SERVICE CENTER
To Next Page
Loading...
Need help?
General
