Instructions for the installer, maintenance
technician and final user
45
6.2.3 Displaying and setting the set point
Press SET for more than 1 second to display the set point;
Increase or decrease the set point using the ▲or▼ buttons respectively, until reaching
the desired value;
Press SET again to confirm the new value.
7 MAINTENANCE
The following section is a basic guide for the general maintenance and cleaning of
the vending machine. Maintenance on the cooling unit may only be performed by
trained specialist staff. While working, always wear protective goggles and gloves.
Maintenance personnel must be made aware of the potential danger in touching hot
metal parts. Even with the power off all the components of the cooling machine may
still be very hot, especially touching the evaporator heater may cause burns.
7.1 Access to Maintenance Area
Access to the internal part of the vendor (maintenance area) is possible using the pecially
provideds key supplied with the Vending machine.
FIG. 7.1 – Access key
To Next Page
Loading...
Need help?
General
