To Next Page
O
obenderAug 11, 2025
What to do if my Venmar HEPA 3.2 doesn't start?
- EElizabeth HernandezAug 11, 2025
If your Venmar Ventilation Hood doesn't start in either the Normal or Boost position, here are a few things you can check: * Verify the breaker or fuse in the main distribution panel. * Ensure there is 120V at the electrical outlet. * Confirm that the unit's main switch is correctly set to the Normal or Boost position. * If a wall control is connected, disconnect the control wire from the unit and then ensure the unit's main switch is properly set to the Normal position.
General
