OPERATING PROCEDURES
POWER-ON
PROCEDURES
POWER-OFF
PROCEDURES
1
2
3
4
Press the Vehicle Power Button
Turn the key in the ignition switch away from the driver
Check your surroundings and press the forward or
reverse switch
Release the parking brake by lightly pressing the
accelerator pedal and slowly press the accelerator
pedal and the vehicle will move
1
2
Turn the vehicle key into the off position
You can eject t he power button, located on the
dash of your cart. Turning the power button off will
disconnect the relay switch, and your cart will not
operate until the power button is inserted again.
!
Always check your surroundings prior to starting your cart as well as before
moving.
The forward and backward switch must be in neutral position (not in forward
or reverse), otherwise the vehicle will not be to move.
If you step on the accelerator pedal rst and then engage the Ignition Switch,
the vehicle will not move. You must release the brake pedal, and then step on
the accelerator pedal again before the vehicle is able to move.
Failure to operate the vehicle as instructed can cause collision, loss of control
or roll over, resulting in severe injury or death. Follow all safety warnings or
labels in this owner manual. All operators must read, understand, and comply
with these warnings and labels before operating the vehicles. Follow the
safety information and operating procedures described.
12
VENOM-EV.COM Venom EV User Guide
To Next Page
Loading...
