18
ENTER
EXIT
DATA & MODE
MENU NAV KEY
Enter - Select in Item
Exit - Saves Value
+/- to select values and nav.
In order for these settings to be programmed into the VR3T 2.4 the following steps must be followed.
1) All model components must be connected correctly. Starting with the receiver, servos, and power supply.
2) The steering and throttle trims on the VR3T 2.4 are set at neutral.
3) Always make sure to turn on the transmitter rst before turning on the receiver.
4) Make sure the transmitters antenna is installed for best input results.
NOTE:
To Next Page
Loading...
Need help?
General