EN 27
Display Function
5
Switch the appliance on or off by tapping the power
button.
6 WIFI Switch the WiFi connection on and off by tapping.
Activate the HOTSPOT mode by touching and holding for
3 sec. You will find a detailed description in the section
“WiFi / hotspot”.
7 AUTO Switch Automatic mode on or off by tapping the AUTO
button.
ON: In the display, AUTO flashes continuously and the ap-
pliance automatically regulates the power level according
to the humidity in the room.
i
When switching on AUTO, the desired humidity
(50 % pre-set) flashes twice and then the measured
humidity in the room is shown in the HUMIDITY display 1.
When the preset humidity is exceeded by more than
5 %, the fan shuts off after approx. 60 sec. and no
power level appears in the speed reading 2. No humidifi-
cation occurs.
OFF: AUTO in the display is continuously illuminated and
the appliance operates with the power level set at 1 – 3.
Set desired humidity 30 – 70 %:
Hold AUTO button for 3 seconds. The HUMIDITY 1
display flashes continuously. Set the desired humidity (in
5 % increments) using the - or + buttons 3. Hold AUTO
button for 3 seconds again until the flashing in display
HUMIDITY 1 stops and the humidity measured in the
room is shown again. Please make sure that automatic
mode is switched on: AUTO flashes continuously in the
display!
To Next Page
Loading...
