IMPORTANT SAFETY INSTRUCTIONS
WARNING1: The appliance should be supplied through a residual current device (RCD) with a rated tripping
current not exceeding 30 mA.
WARNING2: Electric installations should ful
f
ill the requirements of local standards. Earthed appliances must be
permanently connected to fixed wiring
WARNING3:
If
the supply cord is damaged, it must be replaced by the manufacturer or i
t
s service agent or
a similarly qualified person in order to avoid a hazard. Replace damage cord immediately
.
WARNING4:
Parts containing live par
t
s, except parts supplied with sa
f
ety extra-low voltage no
t
exceeding
12 V
,
must be inaccessible to a person in the bath.
WARNING5: To reduce the risk of electric shock, do not use extension cord to connect uni
t
to electric supply
;
provide a properly located receptacle.
WARNING6: Parts incorporating electrical components
,
except for remote control devices, must be located
or fixed so that they cannot fall into the bath.
WARNING7: To avoid electric shock, do not use the spa when i
t
is raining.
WARNING8: Never operate the spa if the suction fittings are broken or missing. Never replace a suction fitting with
one rated less than the flow rate marked on the original suction fitting.
WARNING9: To reduce the risk of injury
,
do not permit children to use this product unless they are closely supervised at
all times.
WARNING10: Water attracts children. Always have
t
he spa locked with its cover af
t
er each use. WARNING11:
When the jet function is going to be used, make sure the cover of spa is opened first.
WARNING12: Do no
t
swi
t
ch on i
f
there is any possibility that the water in the spa is frozen.
WARNING13: Risk of electric shock. Never operate any electrical appliance when in the spa or when your
body is we
t.
Never place any electric appliance, such as a light, telephone, radio, or television
,
within 5 feet
(1.5m)of a spa.
WARNING14: Pets should be kept away from spa to avoid damage.
WARNING15: Risk of electric shock
.
Ins
t
all at least 5 feet (1.5m) from all metal surfaces. As an alternative, a
spa may be installed within 5 feet of metal surfaces i
f
each metal surface is permanently
connected by a minimum 1.0 mm
2
solid copper conductor to the wire connector on the terminal
box that is provided for
t
his purpose.
To Next Page
Loading...
