3. Open the outlet in the outer wall of the spa. Screw one end of inflation hose into it.
4. Pull the plastic plug of
f
from the outlet in the inner wall o
f
the spa, then the water will flow out.
5. When there is no water in the spa, you must put on
t
he je
t
function 2-3minutes by press the “Jet” but
t
on to drain the
water in the air pipeline.
6. When drainage is finished, remove the inflation hose and screw the nut tight.
D Cleaning the spa
Detergent residues and dissolved solids from bathing suits and chemicals will gradually accumulate in the spa’s water
.
To clean the spa, use soap and water then rinse.
Note: do not use hard brushes or abrasive cleaners.
REPAIR AND STORAGE
3. Spa repair
If
the spa is torn or punctured, use the provided repair patch. Dry the area to be repaired. Apply the glue
in the accessory bag to the repair patch and then attach i
t
onto the damaged area. Smooth the surface to remove any air
bubbles. A secure unnoticeable repair can usually be made.
4. Spa storage
Make sure all water is drained from the spa and control box. This is essential to extend the life of the spa. We
recommend the use of a wet/dry vacuum to blow out or suck up water from the spa pipes and pump lines. Remove
It is recommended you store the spa in its original package in a warm dry place.
Note: Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures. Freezing can
severely damage the spa. Improper winterization of your spa may void your warranty.
To Next Page
Loading...
