Ventis HE250R - PART B - INSTALLATION

Page 30
Installation and Operation Manual - HE250R
ENGLISH
6.5.3 Chimney Fire
Regular chimney maintenance and inspection can prevent chimney fires. If you have a chimney
fire, follow these steps:
1. Close the fireplace door and the air intake control;
2. Alert the occupants of the house of the possible danger;
3. If you require assistance, alert the fire department;
4. If possible, use a dry chemical fire extinguisher, baking soda or sand to control the fire. Do not
use water as it may cause a dangerous steam explosion;
Do not use the appliance again until the fireplace and its chimney have been inspected by a
qualified chimney sweep or a fire department inspector.
PART B – INSTALLATION
Install the fireplace only as described in these instructions and using only the following fireplace
components and chimney components from chimney manufacturers listed in "Table 4 : Approved
Chimneys".
• Fireplace;
• Faceplate and louvers;
• Overlay;
• Refractory panels;
• Insulated chimney made by the manufacturers listed in Table 4, with the corresponding specifications:
- Chimney lengths;
- Elbows (where necessary);
- Associated components as per these installation instructions.
Additional Equipment (optional)
• Forced air distribution kit;
• Traditional or modern gravity hot air distribution kit;
• Fresh air kit;
• Fire Screen;
• Heat shield for combustible shelf.