Page 48
Installation and Operation Manual - HE250R
ENGLISH
9.5 Chimney Support Installation
9.5.1 Roof Support
The universal roof support can be used on:
• a roof to support the chimney;
• a floor, ceiling, or roof over an offset to support the chimney or;
• as additional support.
Always follow the manufacturer’s instructions for the maximum chimney height that can be
supported by the support.
9.5.2 Offset Support
This support is used above a chimney offset. When the offset of the chimney
pass through a wall, this support can be installed on the wall to support the
chimney.
9.6 Approved Chimneys
Table 4 : Approved Chimneys
CHIMNEY
MANUFACTURER
MODEL TYPE DIAMETER
Olympia Chimney
SBI Venting Division
Ventis 1" Solid Pack 6" (20 cm)
SBI Venting Division Nexvent 1" Solid Pack 6" (20 cm)
Olympia Chimney Champion Chimney System 1" Solid Pack 6" (20 cm)
Olympia Chimney Rockford Chimney Systems 1" Solid Pack 6" (20 cm)
DuraVent Dura Tech 1" Solid Pack 6" (20 cm)
DuraVent Dura Tech Canada (DTC) 1" Solid Pack 6" (20 cm)
DuraVent DuraPlus HTC 2 "Solid Pack 6" (20 cm)
DuraVent Dura Tech Premium 2" Solid Pack 6" (20 cm)
DuraVent Dura Plus AC Triple Wall 6" (20 cm)
To Next Page
