VentMed DS-7 - Page 33

User Guide
input
VentMed
for 5 cycles
in UT)
recommended that the models
DS-5, DS-6, DS-7, DS-8 be
lines
70% UT
for 25 cycles
IEC
(30% dip in <5% UT (>95 % powered
from
an
61000-4-11.
UT)
dip in
uninterruptible power supply or
a battery.
for 25 cycles
<5% UT
(>95 % dip in
UT)
UT) for 5 sec
for 5 sec
30 A/m
Power
frequency
(50-
30 A/m
Power
frequency
magnetic
fields should be at levels
characteristic of a typical
location in a typical
60 Hz)
magnetic
field
commercial
or
hospital
environment.
lEC
61000-4-8
NOTE UT is the a.c. mains voltage prior to application of the test level.
Annex A: Electromagnetic Compatibility
Information
Guidance and manufacturer's declaration - electromagnetic emissions– this
device is intended for use in the electromagnetic environment specified below. The
user of the device should ensure that it is used in such an environment.
Emissions Test
Complianc Electromagnetic environment-guidance
e
The device users RF energy only for its
internal function. Therefore its RF emissions
RF emissions
CISPR11
Group 1
are very low and are not likely to cause any
32