Ventus W177 - Weather Forecast & Barometric Pressure

to search for the sensors. If that continues to fail, shorten the distance between the sensor & monitor
and reinstall the sensors if necessary (Details refer “INSTALLATION” section)
Anemometer (with built-in temperature & humidity sensor):
Important: Wind direction calibration is needed whenever the anemometer is reset (or during battery
replacement)
Searching mode display
:
Wind direction, temperature & humidity information will flash
RF Connection completed
:
Valid wind speed/direction & Ch-1 temperature/humidity readings appear
RF Connection failed
:
“- - - -“ wind speed appears; no wind direction. Unable to display Ch-1 temperature & humidity
Rain Gauge:
Searching mode display
:
Total rainfall information will flash
RF connection completed
:
Valid total rainfall reading appears
RF connection failed
:
“- - - -“ stops flashing & stays on the total rainfall display (previous daily/weekly/monthly rainfall readings
remain in record)
Additional remote thermo-hygrometer sensor:
Additional remote thermo-hygrometer sensors can be purchased separately (not supplied in the
package).
Important: Select Ch-2 or 3 for additional remote thermo-hygrometer sensor since Ch-1 has been
assigned to the anemometer.
Searching mode display
:
Temperature & humidity information will flash
RF Connection completed
:
Valid temperature/humidity readings of your selected channel appear
RF Connection failed
:
Unable to display the temperature & humidity readings of your selected channel
WEATHER FORECAST & BAROMETRIC PRESSURE
The unit predicts weather condition of the next 12 – 24 hours based on the change of atmospheric
pressure. The coverage area is around 30 – 50 km. The weather forecast is based on atmospheric