iv Arrowboard Operation, Safety and Maintenance Manual –v1 Ver-Mac 2019
Warranty Statement
(Updated February 2016)
Our warranty applies to all equipment newly-manufactured by Signalisation Ver-Mac Inc. subject to
normal use for which the equipment and/or components were intended.
Electronic components manufactured by Signalisation Ver-Mac Inc., are warranted for a period of
twenty-four (24) months from the date of delivery to the original purchaser.
All non-electronic components manufactured by Signalisation Ver-Mac Inc., are warranted for a period of
twelve (12) months from the date of delivery to the original purchaser.
Components not manufactured by Signalisation Ver-Mac Inc. are warranted following the
terms of the component’s manufacturer.
Limitations
The warranty is contingent on the following two conditions:
Signalisation Ver-Mac Inc. does not warrant any of its equipment, or parts thereof, against any
deterioration or damage caused by normal wear, lack of reasonable and proper maintenance, failure to
follow operating instructions, misuse, lack of proper protection during storage, collisions, accidents,
natural catastrophes or unforeseen events.
The equipment has been connected to a power source of the correct voltage and amperage.
Exclusions
Under no circumstances shall this warranty extend to:
Any of our products which have been modified, repaired, or altered in any way, in any establishment
other than the Signalisation Ver-Mac Inc. factory without authorization from Signalisation Ver-Mac Inc.
Replacement parts not supplied by Signalisation Ver-Mac Inc.
The obligations of Signalisation Ver-Mac Inc. shall in no way exceed the initial cost of the equipment or
part upon which such liability is based.
Repair or Replacement
Repair or replacement of any equipment or defective component shall always be at the discretion of
Signalisation Ver-Mac and shall be carried out at its factory, unless otherwise agreed by prior
arrangement with Signalisation Ver-Mac.
Signalisation Ver-Mac shall not be held liable for any cost incurred by the owner in the
execution of repairs.
Signalisation Ver-Mac shall not be held liable for reimbursement of any indirect or incidental
expenses incurred in either the removal of defective equipment or component, nor in the
installation of replacement parts.
The end user is responsible for the cost of shipping, duties and handling related to defective
parts returned to Signalisation Ver-Mac Inc. Signalisation Ver-Mac Inc. will assume the return
cost of shipping via regular service of replacement or repaired parts.
To Next Page
Loading...
General