EasyManuals Logo

Verbatim Store 'n' Go Quick Guide

Verbatim Store 'n' Go
3 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Verbatim Americas, LLC warrants this product to be free from defects in material and workmanship. If this product is found to be
defective, it will be replaced at no cost to you. You may return it with your original cash register receipt to the place of purchase or
contact Verbatim. In the U.S. and Canada, call 800-538-8589. Product replacement is your sole remedy under this warranty, and this
warranty does not apply to normal wear or to damage resulting from abnormal use, misuse, abuse, neglect or accident, or to any
incompatibility or poor performance due to the specific computer software or hardware used. VERBATIM WILL NOT BE LIABLE FOR
DATA LOSS OR ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES, HOWEVER CAUSED, OR FOR BREACH OF ANY IMPLIED
WARRANTIES, INCLUDING MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This warranty gives you specific legal
rights and you may also have other rights which vary from state to state. Certain states do not allow limits on consequential damages,
so these limitations may not apply to you.
Note: Verbatim Americas, LLC may at any time revise the content of this user guide without further notice.
LED Status Indicator:
Store ‘n’ Go’s LED status indicator provides the following information:
LED Flashing Slowly: Device connected and ready for use.
LED Blinking: Device in use. (Data is being accessed or transferred.)
Note: Do not remove the device while the LED is blinking, as data may be corrupted or lost.
LED Off: Device is in low power suspended mode.
Carrying Store ‘n’ Go:
You can put Store ‘n’ Go in your pocket, purse, on your key ring or attach it to a carry lanyard. Avoid temperature extremes, shock,
and moisture. If your Store ‘n’ Go is accidentally exposed to water, allow it to dry thoroughly before using.
Note:
It is important to maintain a backup copy of any critical data to safeguard against device loss or other malfunction.
Specifications:
Interface: USB 2.0 (also compatible with USB 1.1 ports)
Power Supply: USB bus powered (No external power required)
Operating Temperature: 0 degrees C to 60 degrees C
Storage Temperature: -20 degrees C to 70 degrees C
Environment: Relative Humidity: 5% to 90% RH
Altitude: Operating: 6,096m (20,000 feet)
Storage: 12,192m (40,000 feet)
Vibration: 5G RMS, 10 to 2,000Hz, 0.5 Oct/min sweep rate
Shock: Non operating 55G, 11ms, half-sine
Certifications: FCC, CE, VCCI, WHQL
VERBATIM LIMITED LIFETIME WARRANTY

Other manuals for Verbatim Store 'n' Go

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Verbatim Store 'n' Go and is the answer not in the manual?

Verbatim Store 'n' Go Specifications

Operating Environment IconOperating Environment
operating temperature0 degrees C to 60 degrees C
storage temperature-20 degrees C to 70 degrees C
relative humidity5% to 90% RH
Altitude and Vibration IconAltitude and Vibration
operating altitude6, 096m (20, 000 feet)
storage altitude12, 192m (40, 000 feet)
vibration resistance5G RMS, 10 to 2, 000Hz, 0.5 Oct/min sweep rate
Power and Interface IconPower and Interface
interfaceUSB 2.0 (also compatible with USB 1.1 ports)
power supplyUSB bus powered (No external power required)
shock resistanceNon operating 55G, 11ms, half-sine

Related product manuals