Verifone VX805 Integration Guide
Note: Before this integration can begin, you will need your VAR sheet or Setup letter from
Verifone. If you do not have this information, you can contact Verifone on 1-800-VERIFONE.
This integration is only compatible with Windows till systems.
Installing the app
1. Log in to your Epos Now Back Office
2. Head to Apps along the left-hand side
3. Use your touchscreen keyboard to bring up the URL bar by pressing CTRL + F12
4. Select any app showing on the home screen of the app page - you will see an address in
the URL bar with some numbers at the end
5. Remove the numbers from the end of this URL and replace them with 253
6. Press enter on your keyboard
7. Install the Mercury EMV app (this app is free to install)
This completes the installation of the payment app on your till software.
Activating the app
1. Log in to your Epos Now Back Office
2. Head to the Setup tab (top left corner)
3. Select Locations
4. Select Locations and Devices
5. Scroll to the right on your location, select Show Devices
6. Locate the device you wish to connect the card reader to, select Edit
7. Scroll to the right, tick the Mercury tick box
8. Scroll to the left, select Update
Mercury will now show as enabled on the device.
Configuring the card reader
Downloading the card reader software
Click here to download the software. Follow the steps below to continue with the installation:
1. You will see the folder downloading in the bottom left hand corner, select the download
2. Select open and run
To Next Page
Need help?
General
